Hi, I purchased a old dell poweredge 2950. I plug in the 15K 300GB drive and it spins up. RAID recognises it and when I boot into the windows server 2012 install it does not recognise the drive.
Active3 years, 7 months ago
Purchased a MD1000 from craiglist, came with two SAS 5/E cards and cables. I dug out an old 2950, put server 2003 (32bit) on it, put in one of the cards, installed / updated firmware, etc. Matrox dualhead2go mac software download. When I boot, I see:Dell SAS 5 Host Bus Adapter BIOS
then later, CTRL-C to run SAS Configuration Utility
Free Download Dell PowerEdge 1850 SAS 5/E Adapter Non-RAID Controller Driver (Other Drivers & Tools). In contrast, I have a Dell MD1000 populated with the same number and type of disks as above and connected to the same server (but to a PERC 5/e) and for sequentail tests I am seeing 520MB read and 350MB write and for 512KB tests I am seeing 56MB/sec read and 80MB/sec. Press CTRL-C to run Dell SAS 5 Configuration Utility. This message appears when multiple SAS 5 HBA's are moved within the system without proper boot order selection in the system BIOS. Start the Configuration Utility and select the boot order of the SAS 5 HBA in the system BIOS. Displays while the BIOS is waiting to initialize. The Dell™ Serial-Attached SCSI (SAS) 5 Host Bus Adapters (HBAs) require software drivers to operate with the Microsoft® Windows®, Red Hat ® Enterprise Linux ®, and SUSE ® Linux operating systems.
then later, I can press CTRL-R to config the PERC 6/i
I found post where Dell doesn't support the MD1000 connected to a SAS 5/E. When I go looking on ebay for a PERC 5/E card, they look very similar to what I have now..
House party for mac. Looking for direction on how to get the 2950 and MD1000 connected.. should I get a card off ebay, even if it looks very close to what I have now? Is there a way to tell a difference
Kevin BakerKevin Baker
1 AnswerDell Mac Drivers
The MD1000 is a 'JBOD' enclosure. Solid state drive for mac. The device that it connects to gets presented with access to all of the hard drives. If the device is a PERC 5/e controller, the card can manage the drives for you in RAID sets, and present Virtual Disks to the OS.
With a SAS 5/e card though, you would end up seeing every single hard drive separately in the OS (if it even worked - as you said, it is actually an unsupported config).
If you want a setup that is validated to function properly, go for the PERC 5/e card.
Konica Minolta Drivers For Mac
The MD1200 + SAS 6/E cards is supported now with Server 2012 and Storage Spaces to manage the drives.. I would be curious whether or not you could get this to work on the hardware you have now, as the PE2950 does support Server 2012 (non-R2). Might be worth a try!
Samsung Printer Drivers For Mac
JimNimJimNim
Epson Drivers For MacNot the answer you're looking for? Browse other questions tagged windows-server-2003dell-poweredgedell-powervault or ask your own question.Comments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |